Der Bootloader wird genauso wie ein normales Image über Usb geflasht,
Bootloader upgrade
1. Unzip the attached file then 'et4x00' folder will be appeared.
2. Copy that folder into the USB medium
3. Insert USB medium into either USB sockets on the front or rear panel.
4. Power Off and Power On using the power switch at the rear panel of the box.
5. After Power On, ET4000 model will detect if there is his software available on the USB medium.
6. Press 2x ‘CH – ‘ button on the front panel.
7. ET4000 model gets into state of upgrading.
8. The box will startup automatically after the upgrade is finished.
--> Datei ist nicht mehr vorhanden <--
Bootloader upgrade
1. Unzip the attached file then 'et4x00' folder will be appeared.
2. Copy that folder into the USB medium
3. Insert USB medium into either USB sockets on the front or rear panel.
4. Power Off and Power On using the power switch at the rear panel of the box.
5. After Power On, ET4000 model will detect if there is his software available on the USB medium.
6. Press 2x ‘CH – ‘ button on the front panel.
7. ET4000 model gets into state of upgrading.
8. The box will startup automatically after the upgrade is finished.
--> Datei ist nicht mehr vorhanden <--
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von christian24100 ()